| Description for Image 1: This gallery shows the MCP panel paper and transparency parts glued together, with two rotaries stuck through temporarily. | |
| Description for Image 2: closer view of the left side. the Heading selector is actually a home built co-axial rotary, based on ideas of some finnish homebuilders | |
| Description for Image 3: the middle part with the vertical speed indicator | |
| Description for Image 4: and the right part, with another rotary switch for the Altitude selector | |
| Description for Image 5: its thin, no plexi backer yet | |
| Description for Image 6: the base of the rotary on the backside | |
| Description for Image 7: once more | |
| Description for Image 8: the 4mm brass rod serves as the inner axis this is for the Heading select itself while the outer knob sits on the 6mm plasic axis of the rotary, into which I drilled a 4.5mm hole where the brass rod goes through | |
| Description for Image 9: the altitude selector is the same component as the bank angle/heading selector, just unmodified | |
| Description for Image 10: the backside of the panel | |
| Description for Image 11: closeup of the left side | |
| Description for Image 12: center | |
| Description for Image 13: and right side | |
| Description for Image 14: the co-axial heading/bank angle selector in profile view | |
| Description for Image 15: even closer from the back side | |
| Description for Image 16: and the same agin from the front | |
| Description for Image 17: the inner knob pulled further out | |
| Description for Image 18: backlightable | |
| Description for Image 19: a little dark in this picture | |
| Description for Image 20: and a little brighter | |
Generated by mkwebgallery.sh version 0.1.5 | |