| Description for Image 1: closer view of the throttle and reverser handles 1+4 | |
| Description for Image 2: same thing, different angle | |
| Description for Image 3: closer view of the flaps handle. it is made from wood, and has a couple of coatings of wood glue (Ponal) | |
| Description for Image 4: throttle handles again the handles are attached to a aluminum strip, which in turn is attached to a 2mm steel lever that sits on a threaded rod (M6) movement is translated to the pots through those yellow plastic gears. | |
| Description for Image 5: the yellow plastic gear wheels are clearly visible | |
| Description for Image 6: the pots are already wired up... | |
| Description for Image 7: the pots are mounted on these aluminum brackets | |
| Description for Image 8: better angle | |
| Description for Image 9: this shows it nicely | |
| Description for Image 10: from the front... | |
| Description for Image 11: closeup from front | |
| Description for Image 12: the mechanism from front in closeup, sorry the picture is a little fuzzy | |
| Description for Image 13: better picture of potentiometer and gear wheels | |
| Description for Image 14: the inset of the throttle unit this acts as a guide for the levers | |
| Description for Image 15: here's how it looks set in place | |
| Description for Image 16: two throttle levers with the handles removed | |
| Description for Image 17: looking from the top | |
| Description for Image 18: looking from the right | |
| Description for Image 19: the stoppers visible here | |
| Description for Image 20: stoppers at the other end | |
| Description for Image 21: another angle | |
Generated by mkwebgallery.sh version 0.1.5 | |