| Description for Image 1: Here are some pics of the new flap notches made from the famous :-) bread cutting board :-) stuff. The thickness comes nearer to the original than our old solution with the board. | |
| Description for Image 2: As you can see, I'm changing quite a bit at the throttle unit. I am also planning on using MVDTs (Mikes LVDT :) instead of the potentiometers. (for more infos on LVDTs see http://www.mikesflightdeck.com/lvdts.htm) | |
| Description for Image 3: I've also added the "guards" at both ends of the notch-piece. | |
| Description for Image 4: Its not made of one piece but of three pieces since I used a small (standard) sized bread cutting board. BTW One such bread cutting board (14x20.5cm) costs about 2.20 EUR where I found them. | |
| Description for Image 5: This shows the thickness of it. In numbers: 7mm | |
| Description for Image 6: Each of the three pieces is attached via 2 small wood screws. | |
| Description for Image 7: As I said, the throttle unit is a construction site(or: a big mess :-) at the moment. | |
Generated by mkwebgallery.sh version 0.1.5 | |